• Over 46 million magnets in stock
  • Customer service in 3 languages
The product was added to your shopping cart.
Go to shopping cart

Faceplate for Screws

Stable, well-adherent covering caps hide counter-sunk screws
Author: R.E., Laupen (ZH)
Online since: 07/05/2008, Number of visits: 285319
0
The problem: How do I make a simple, strong-holding and nice-looking faceplate for inset screws in a wooden frame?
The do-it-yourself shop does sell such covers but the shaft is often too long and too narrow for a good hold.
My solution: Get me some super magnets!
With a knife, carefully trim 2 mm off the end of the shaft. Push a suitable disc magnet or ring magnet into the hollow shaft. For the caps in the picture a ring magnet type R-06-02-02-G was used.
The faceplate now holds to the screw by itself!

The entire content of this site is protected by copyright.
Copying the content or using it elsewhere is not permitted without explicit approval.