Hose on grinder
This hose stays where it is needed
Online since: 07/08/2008, Number of visits: 308852
I work on a grinding machine. After each grinding process I need to rinse the grinding table. I did not have the opportunity to hang up the hose nearby.
Super magnets helped me to implement a new solution.
I used a standard cable tie and drilled a small hole into it.
Thereafter, I fit a M4 screw through the hole...
Then, I attached the cable tie (e.g. Plastic cable ties 200 x 5,00 mm or Plastic cable ties 400 x 5,00 mm) to the end of the hose.