Hose on grinder
This hose stays where it is needed
Online since: 07/08/2008,
Number of visits: 349276
0
I work on a grinding machine.
After each grinding process I need to rinse the grinding table.
I did not have the opportunity to hang up the hose nearby.
Super magnets helped me to implement a new solution.
I used a standard cable tie and drilled a small hole into it.
Thereafter, I fit a M4 screw through the hole...
...
and attached a pot magnet type TCN-16
to it.
Then, I attached the cable tie (e.g.
Plastic cable ties 200 x 5,00 mm
or Plastic cable ties 400 x 5,00 mm) to the end of the hose.
Now, I can easily hang up the hose on the machine.
It sticks like a limpet :-)
Articles used
Load...
| 5 pcs. | 1,60 EUR ea.* | |
| from | 15 pcs. | 1,42 EUR ea.* |
| from | 40 pcs. | 1,29 EUR ea.* |
| from | 80 pcs. | 1,21 EUR ea.* |
| Ask for a rebate from 260 pcs. | ||
Available: 27 495 pcs.
0 people like this customer project
-Projects are bookmarked in your customer account
keywords
The entire content of this site is protected by copyright.
Copying the content or using it elsewhere is not permitted without explicit approval.
Copying the content or using it elsewhere is not permitted without explicit approval.
